The quality of the vaccine bottle is related to whether the veterinary vaccine can be effectively stored, and will also affect the effect of animal immunity in the later stage, which is of great significance to the sustainable and healthy development of animal husbandry. Factors that affect the quality of vaccine bottles include bottle sealing, drop resistance, sterility, etc. In addition, the quality of bottle caps is also one of the important factors affecting their quality.

100ml PP vaccine vial

250ml PE plastic vaccine bottle

Vaccine bottle caps generally use rubber stoppers and aluminum caps. In YBB00082005-2015 "Aluminum Caps for Injection Bottles", the quality standards for aluminum caps are specified in detail:

[Appearance] Take an appropriate amount of this product, place it in a place with bright natural light, and observe visually, it should be clean without residual lubricant, burr, or damage.

[Mechanical properties of aluminum parts] The tensile strength of the material should be 130-180N/mm, and the elongation should not be less than 2%.

[Convexity] Take an appropriate amount of this product, measure with a vernier caliper, accurate to 0.1mm, and the convexity should not exceed 3%.

[Opening force] B (two-bridge), C (three-bridge) type aluminum cover opening force: 25N<B type tear sheet<60N, 46N<C type tear sheet<76N; D (tear-off type) aluminum cover Tear force: 30N<bridge breaking force<50N; 5N<full opening force<25N.

[Thickness] The thickness should be determined within a given range through negotiation between the supplier and the buyer, and the thickness and tolerance should not exceed ±0.022mm.

[Sterilization resistance] Take an appropriate amount of this product, rinse it with water, and bake it in an oven at 180°C for 1 hour, there should be no obvious change on the surface, and there should be no bulge and detachment on the surface layer.

[Compatibility] Take an appropriate amount of this product after baking in an oven at 180°C for 1 hour, cover it on a suitable bottle with a nominal capacity of water (with a rubber stopper), and seal it with a capping device. Fracture and abnormal deformation.

[Coating firmness] Take an appropriate amount of this product (suitable for coated aluminum covers on the outer surface), bake in an oven at 180°C for 1 hour, and then wipe the surface with absorbent cotton soaked in 80% (V/V) ethanol solution for 30 Seconds, and then wipe the surface with absorbent cotton soaked in 70% (V/V) isopropanol solution for 30 seconds, the coating should be free of any abrasion.

Animal diseases have always been a major factor restricting the development of my country's animal husbandry. To do a good job in the prevention and control of animal diseases, reduce the incidence of infectious diseases, and promote the healthy development of my country's animal husbandry requires the joint efforts of every vaccine manufacturer and vaccine bottle supplier.